Page 6 of 14 Hurricane™ 901 User Manual (Rev. 2)
3. SETUP
AC Power
This product has a fixed voltage power supply and it can work with an input voltage of
either 120 V, 60 Hz or 230 V, 50 Hz, depending on the specific model.
Make sure that the model of your Hurricane™ 901
fogger matches the voltage of
the power outlet to which you want to connect it, whe
Connecting this product to the wrong input voltage would
may permanently damage the Hurricane™ 901.
To determine the power requirements for
this product (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product’s back panel, or
refer to the product’s specifications chart. The listed current rating indicates the
product’s average current draw under normal conditions.
Always connect this product to a protected circuit
(circuit breaker or fuse),
making sure that it has an
appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect this product to
a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Fuse
This product uses an F 10 A, 250 V fuse
. Follow the instructions below to change it in
case it blows.
Disconnect this product from the power outlet before replacing the fuse.
1) Wedge the tip of a flat head screwdriver into the slot of the fuse holder and pry it out
of its housing.
2) Remove the blown fuse from its holder and replace it with a fuse of the exact same
type and rating.
3) Insert the fuse holder back into its place, and reconnect power.
Always replace a blown fuse with a good fuse of the same type and rating.
Although the safety cap does have room for a spare fuse, this product ships with
no spare fuse.
Installed fuse
(held by plastic clip)
Spare fusel
(inside safety cap)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels