Chauvet DMX-690 Manuel d'utilisateur télécharger pdf (Page 7)

3. SETUP

Lamp

You will need to install a lamp prior to the initial operation of the fixture. A 150W HTI lamp is included.

Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the

unit to cool down! Always disconnect from main power prior to lamp replacement.

Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp

with alcohol and wipe it with a lint free cloth before installation.

Lamp Replacement

Figure A

Figure B

Lamp Access Screws

1) Remove the four screws indicated in

Figure A to access the lamp.

2) Hold the lamp with a lint-free cloth,

and pull the lamp directly

out of the

socket as shown in Figure B.

Note: One lead of the lamp is larger than

the o

ther. Make sure the large lead

goes in the large socket. If the lamp

won’t insert into the socket, try

turning it around and reinserting it.

3) Hold the new lamp with a lint-free

cloth, and insert directly

into the

socket.

4) Reinsert the lamp housing into the

fixture, an

d tighten the four screws

removed in step 1.

Note: The lamp may need to be aligned. If

so, follo

w the lamp alignment

procedures on the following page.

Intimidator Spot 2.0 HTI Manual 7 2007-01-24/09:36

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Pas de commentaire

Chauvet DMX-690 Manuel d'utilisateur Page 7