Chauvet Techno Strobe 168 Manuel d'utilisateur Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
Page 12 of 16 Techno Strobe168 User Manual (Rev. 2)
DMX Channel Modes, Assignments, and Values
2-Channel
Channel
Function Value Percent/Setting
1 Control Functions
000 005
006 240
241 250
251 255
No function
Strobe speed, slow to fast
Full On (all LEDs on)
Sound-Active mode
2
Dimmer
000 255
0~100%
Configuration
(Standalone)
Set the product in one of the standalone modes to control without a DMX controller. The
standalone modes are accessed through the DIP switches located on the back panel.
1. Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode (either Static,
Automatic, or Sound) to a DMX string connected to a DMX controller. Products in
standalone mode may transmit DMX signals that could interfere with the DMX
signals from the controller.
Sound-
Active
Mode
To enable the Sound-Active mode, do the following:
1. Set all DIP switches to Off.
2. Turn the Speed Adjustment knob counterclockwise to the minimum position.
3.
Turn the Intensity Adjustment knob until the product starts responding to the beat of
the music.
The product will only respond to low frequencies of music (bass and drums).
Strobe Mode
To enable the Strobe mode, do the following:
1. Set all DIP switches to Off.
2. Turn the Speed Adjustment knob between the minimum and maximum positions to
the desired strobe speed.
All-On Mode
To enable the All-On mode, do the following:
1. Set all DIP switches to Off.
2. Turn the Speed Adjustment knob clockwise to the maximum position.
Due to its innovate design, this unit can be run strobing all night, but continuous
All-
On operation should not be used for more than 30 minutes at 120V or 15
minutes at 230V.
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire