Chauvet Tiger DMX 60 Manuel de l'opérateur télécharger pdf (Page 47)

7. Chases - Page 39

Pearl 2008 Manual - 16th July 2007

 Press the Go button to go on to the next cue.

You can also set a text label for each cue. The Pearl will show you the

label for the current cue and the next one coming up. The reference

manual tells you more details about this.

7.10 Sound activation of chases

The Pearl can use bass, mid or treble (low, medium or high)

frequencies from its audio input to trigger chases. Any chase can be

programmed to respond to Bass, Mid or Treble frequency triggers.

There is also a master “Sound to light enable” option.

Sound mode only works with the key turned to Run, but you need to be

in Program mode to set up the chase for sound activation.

Sound activating chases

 In Program mode, turn on the chase to “connect” it.

 Press A [Chase Parameters]

 Press E [Sound to light] to select Sound to Light Low, Medium or

High

 Turn the key to Run mode.

 Press E [Sound to light]. (This is the master sound to light enable

control) The option will highlight.

 All chases with sound enabled will step in time to the sound signal

 The Speed wheel controls the maximum speed of the chase

 Press E, again, to turn off sound activation.

Also while in Run mode you can set the speed of the connected chase

manually by tapping Softkey G [Tap twice to set tempo] in time with

the music.

7.11 Examples

How do I program a dimmer chase?

Create the chase by pressing Chase then one of the flashing (empty)

playback swop buttons. Press Clear, and turn on the dimmers for step

1. Press the Swop button for the chase to save the step. Press clear,

then turn on the dimmers for step 2, and press the Swop button to

save. When you have saved all the steps, press Chase to end.

I’ve programmed a chase using memories but when I turn it on,

nothing happens

To use existing memories in a chase, you must use the Include function

to load the memory into the programmer. If you just turn on a memory

and then try and save that as a chase step, nothing will be saved

because the memory will not be in the programmer.

The last step of my chase doesn’t play back

You need to press Clear to clear the programmer (which overrides the

chase output).

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 205 206

Pas de commentaire

Chauvet Tiger DMX 60 Manuel de l'opérateur Page 47